Tsurumi LSC1.4S - Puddle Sucker Pump

TSURUMI are the manufacturer of the LSC1.4S puddle sucking pump. The manufacturer offers a 3-year product guarantee as standard, giving the added reassurance that you will get a product that is built to last.

Aptly named the puddle-sucker, the LSC1.4S is capable of pumping water down to just 1mm, making it the perfect choice of pump if you are looking to pump either big or small areas of water that can be found on flat surfaces. The common applications for the LSC1.4S puddle sucker are hire fleets, flood control, lift shafts, fixed installations, utilities and in construction.

Due to the design, and the dual-position outlet port, the outlet hose for this pump can be positioned vertically or horizontally. For additional sturdiness, the outer casing is made from pressed steel and a pump stand made with cast aluminium. The puddle sucker pump delivers its promise of extreme reliability and high performance. To prevent the back-flow of water coming from the discharge hose, there is an integral swing check valve included.

This pump can comfortably operate for prolonged periods of time with very little, or no water at all due to the air and water cooling route to the top outlet.

110V: designed for heavy-duty site use, however, a transformer is needed in order for them to operate.

230V: compatible with standard domestic 3 pin plug sockets.

The pump can be supplied as a manual or automatic models.

Alternatives:

You may wish to also consider the Stream SPK530 for a cost effective alternative, or for a more powerful puddle pump, you may wish to use the EVAK Residox.

Automatic models:

For fixed installations the SwitchH20 and Panel is recommended. This consists of 3 probes in 304 stainless steel. It is supplied with a control panel and 10m of cable. It allows automatic pumping down to 5mm.

For portable use, the Sensor is recommended. This is an electronic float switch with 2 stainless steel probes. They are encapsulated in an impact resistant moulded rubber. This can still be used for fixed installations or narrow sumps. As an optional extra, extension probes are available to enable pumping down between 85mm and circa 1mm. The extensions are an optional extra and available here: 170mm Sensor Extension Probes.

When the probes touch water, the pump will start and continue to operate for one minute after the water falls below it. However, if the water touches the probe within this time, the “stop” signal is cancelled and the pump continues to run until the water is cleared. 

Please note: As standard we supply 25mm outlets. Please select 50mm if you require a 50mm outlet.

What's in the box:

• 1x LSC Pump
• 1x 10m Heavy duty rubber power cable
• 1x Hose tail