PUMP CATEGORY

Flood Control Equipment, Pumps, Barriers & Property Protection

Flood control equipment for managing water before, during and after a flood event. This collection brings together pumps used to remove flood water and physical barriers used to keep it out. You will find puddle pumps, submersible pumps,...

Products in range 43
From £15.48£12.90 (Exc VAT)
Use case Flood mitigation
Advice Engineer-led
43 products
Flood Protection Solutions

Floodshield Door Flood Barrier

  • Comes ready to use straight out the box
  • Fitted in minutes
  • No tools required
  • No fixtures or alterations
  • Cannot be stolen once the door is closed
£374.17 £311.81 (Exc VAT)
In stock
View
EVAK★ 4.88

EVAK Residox 400 Manual Puddle Pump

  • Ultra-low-level manual puddle pump, removes water to approximately 1 mm
  • 250 l/min flow, 11 m head, suited to domestic and light commercial flooding
  • Stainless steel build, cast iron housing, Hytrel impeller
  • Surface-safe rubberised base for finished floors
  • 110V or 230V, no priming required
£382.50 £318.75 (Exc VAT)
In stock
View
Flood Protection Solutions★ 5.0

EGO 500 SE LS Automatic Puddle Pump | Adjustable Electronic Sensors

  • The fully automatic EGO 500, draws water down to 1mm without manual intervention
  • Adjustable electronic sensors replace the mechanical float
  • Set start level anywhere from 125mm down to 15mm
  • Set stop level down to 3-5mm with run-on for 1mm pumping
  • Supplied with non-return valve
£257.50 £214.58 (Exc VAT)
In stock
View
Flood Protection Solutions★ 5.0

EGO 500 GI Submersible Puddle Pump | Dual Manual & Automatic

  • The original EGO 500 with 9mm solids handling for debris-laden water
  • Dual manual or automatic operation via float switch
  • Auto mode starts at 130mm, stops at 70mm
  • Manual mode pumps down to 10mm
  • 230v 3 Pin Domestic Plug
£169.00 £140.83 (Exc VAT)
In stock
View
Flood Control: Removing Water and Helping Stop It Getting In

Flood Control: Removing Water and Helping Stop It Getting In

Flood control is about managing water when it arrives, not just preventing it. Effective property-level flood response usually combines two elements: removing water that has already entered, and preventing further ingress. This collection covers both.

The right approach depends on the source of flooding, the depth and volume of water, whether mains power is available, and how quickly water needs to be moved.

For active flood situations, pumps are the priority. For properties at known risk, barriers and protection measures are typically deployed in advance.

Pumps for Flood Water Removal

Pumps for Flood Water Removal

In an active flood, pumps are often a first line of response. The correct choice depends on water depth, required flow rate, and available power on site.

Puddle Pumps

Designed to remove water down to very low residual levels, typically 1–5mm. These are used for final clean-up after flooding or where a standard submersible pump leaves water behind. Suitable for clean to lightly contaminated water.

Submersible Flood Pumps


General-purpose pumps for moving large volumes of water quickly. Commonly used in flooded basements, garages, cellars, outbuildings and external areas. Most models handle clean to lightly soiled water, with sewage-rated options available where contamination is present.

Engine-Driven Pumps

Used where mains power is unavailable, has failed, or where higher flow rates are required. Suitable for severe flooding, agricultural land, remote sites and large-scale dewatering. Available in petrol and diesel depending on duty requirements.

Packaged Pump Stations

Permanent, automatic systems installed below ground to manage water as part of a long-term flood resilience strategy. Typically used where water needs to be lifted and discharged automatically, such as basements, low-lying properties, or developments below sewer level.

If you are unsure which pump is suitable, use the Water Pump Performance Calculator to estimate flow rate and head requirements.

Buying guide

More about this category.

The deeper read: what's in this range, how to pick, and when to talk to us before you buy.

Puddle Pumps

Designed to remove water down to very low residual levels, typically 1 to 5mm. These are used for final clean-up after flooding or where a standard submersible pump leaves water behind. Suitable for clean to lightly contaminated water.

Submersible Flood Pumps

General-purpose pumps for moving large volumes of water quickly. Commonly used in flooded basements, garages, cellars, outbuildings and external areas. Most models handle clean to lightly soiled water, with sewage-rated options available where contamination is present.

Engine-Driven Pumps

Used where mains power is unavailable, has failed, or where higher flow rates are required. Suitable for severe flooding, agricultural land, remote sites and large-scale dewatering. Available in petrol and diesel depending on duty requirements.

Packaged Pump Stations

Permanent, automatic systems installed below ground to manage water as part of a long-term flood resilience strategy. Typically used where water needs to be lifted and discharged automatically, such as basements, low-lying properties, or developments below sewer level.

Property-Level Flood Protection

Pumps deal with water once it has entered. Physical flood protection products are used to reduce or prevent water entering in the first place, typically deployed when a flood warning is issued.

  • Door and opening barriers – Installed across doorways and openings to block surface water entry
  • Water-activated – Sandbag alternatives that expand on contact with water to seal thresholds and gaps
  • Airbrick covers – Prevent water ingress through airbricks, a common source of internal flooding
  • Rapid-response flood kits – Pre-assembled kits for fast deployment during flood warnings

These systems are most effective when used together. A typical setup combines a door barrier, airbrick covers and a flood kit, supported by a pump for any residual water.

Important Information: Bespoke Barriers and Flood Risk Surveys

Flood & Water Pumps is part of Flood Protection Solutions Ltd, within the wider FPS Group®.

If you require a bespoke or permanent flood barrier system (such as aluminium demountable barriers engineered for a specific opening), these are not stocked products and are designed on a project basis. You can obtain a quote from Flood Protection Solutions here: Flood Barrier Enquiry.

If you require a flood risk survey, site assessment or engineered flood resilience design, this is delivered through FPS Environmental Ltd on a formal instruction basis.

This collection is product supply only. Where a project requires investigation, design or consultancy input, these services are provided separately by the consultancy team.